Mguard rs2000 update#
Mguard rs2000 software#

ICS-CERT reminds organizations to perform proper impact analysis and risk assessment prior to deploying defensive measures. Also recognize that VPN is only as secure as the connected devices. When remote access is required, use secure methods, such as Virtual Private Networks (VPNs), recognizing that VPNs may have vulnerabilities and should be updated to the most current version available.Locate control system networks and remote devices behind firewalls, and isolate them from the business network.Minimize network exposure for all control system devices and/or systems, and ensure that they are not accessible from the Internet.NCCIC/ICS-CERT recommends that users take defensive measures to minimize the risk of exploitation of this vulnerability. Links to updates and additional information can be found in the advisory at the following location:

Mguard rs2000 update#

PHOENIX CONTACT and Innominate Security Technologies recommend all users running mGuard devices with affected firmware versions to update to firmware Version 8.5.2 or higher, which fixes this vulnerability. Successful exploitation of this vulnerability could allow attackers to cause a remote denial of service and force a restart of all IPSec connections. The following versions of mGuard firmware versions 8.0.0 to 8.5.1, running on these mGuard Network Security Appliances, are affected:

Vulnerability: Null Pointer Dereference AFFECTED PRODUCTS Vendor: PHOENIX CONTACT, Innominate Security Technologies Storage: 30g, 11 ms period, half-sine shock pulseįree from substances that could impair the application of coatingĪccording to P-VW 3.10.ATTENTION: Remotely exploitable/low skill level to exploit. Operation: 15g, 11 ms period, half-sine shock pulse Standards and Regulations Electromagnetic compatibility Supported Supported Supported DES, 3DES, AES-128, -192, -256 ESP tunnel / ESP transport Supported Supported X.509v3 certificates with RSA or PSK MD5, SHA-1 Quick mode, Main mode, PFS RFC 3706 Incoming or outgoing traffic Standard routing, NAT, 1:1-NAT, port forwardingġ0 V DC … 30 V DC (depending on the operating voltage) Integrated TCP/IP stack, firewall and VPN support, independent connection establishment. After a voltage interruption, there is automatic redialing into the network. GSM / GPRS / EDGE / UMTS / HSPA / LTE (FDD)Ĥ time slots for receiving data, 4 time slots for transmitting data.

Mguard rs2000 software#

Software handshake, Xon/Xoff or hardware handshake RTS/CTS UART/NRZ: 8 Data, 1/2 Stop, None/Even/Odd Parity Router with simplified 2-click firewall and VPN for 2 tunnels (fixed), metal housing, slot for any SD memory card AWG conductor cross section, flexibleĮthernet interface, 10/100Base-T(X) in acc. Test voltage data interface/data interfaceĬonformance with RED Directive 2014/53/EUĥ82 Years (SN 29500 standard, temperature 25 ☌, operating cycle 21 % (5 days a week, 8 hours a day))Ģ71 Years (SN 29500 standard, temperature 40 ☌, operating cycle 34.25 % (5 days a week, 12 hours a day))ġ14 Years (SN 29500 standard, temperature 40 ☌, operating cycle 100 % (7 days a week, 24 hours a day))ġ1 V DC … 36 V DC (via pluggable COMBICON screw terminal block) ≤ 5000 m (For restrictions, see the manufacturer’s declaration for altitude operation) LoRaWAN Devices and Sensors (Long Range)Īmbient conditions Ambient temperature (operation).

ALTA Wireless (Medium Range – Battery Powered).

Edge Devices, Controllers & I/O Modules.